ANSI Cast Iron Gate Valve with socket Welded Ends GV-H-A06

Quick Detail
Design standard: AWWA C509
Body material: ductile iron
Wedge: Ductile iron+ Rubber EPDM
Nominal diameter: 6″?
Pressure: 250PSI 250WOG
End connection: Socket Welded IPS
Face to face: ANSI B16.10
Working temperature: -30℃~+120℃.
Test and inspection: API 598.
Gland Gate valve
Operation: Square Nut

Optional Connection: SW, Ring tie joint IPS for pvc pipes
MJXMJ / Flange x MJ / SOCKET Ends X flange
Optional Material: Ductile iron/Cast iron body and bonnet
Optional Seat: Bronze, brass, stainless steel, EPDM
Design: non-rising stem/ Rising Stem
Surface treatment: Fusion bonded epoxy coating red, black, blue
Standard Meets AWWA C515/ AWWAC509/ ANSI
Size Range; 2″-12″
Pressure Range: 150PSI, 225PSI, 250PSI

The American Water Works Association (AWWA) Standards C509 and C515 set the minimum design requirements for resilient seated gate valves. Other gate valve manufacturers strive to design their valve as close to the minimum as possible and still be in compliance with the AWWA standards. DEYE Valves with materials that exceed the minimum set out by the AWWA standards.

The body and bonnet that can be made of cast grey iron, ductile iron. DEYE Valve
manufacturing all cast components of ductile iron (Including the body, bonnet, wedge, seal plate, and operating nut). The tensile strength of the cast ductile iron is 65,000 psi with a 12% elongation property. The tensile strength of most cast grey iron is 30,000
psi with less than 1% elongation.

Water supply and drainage, water treatment, water diversion works, etc.